INDUSTRIAL OVEN FOR THE POST CURING PROCESS – AMARC srl

INDUSTRIAL OVEN FOR THE POST CURING PROCESS

The oven purchased by a multinational operating in the sector of roller bearings, seals, mechatronics, lubrication services and systems.

The oven is used for post curing of metallic components after they are machined which, subjected to temperatures > 150°c emit large amounts of fumes at high density, difficult to control.

This process problem played a significant role on the design.

The inner chamber was made of AISI304 stainless steel (to overcome possible corrosive effects) and completely sealed (to overcome undesirable passage of fumes between the panels outwards).

In addition, for protection of the operator, the following were provided: fumes extraction cycle interlocked with the heating cycle, electric lock with positive safety interlocked with the extraction cycle.

(An internal release rope is provided with door release switch with anti-entrapment action).

Technical data

Thermoregulation areas: 1
Working dimensions WxDxH in mm: 1500 x 1450 x 2100
Installation site : Indoor
Heating power supply: Electric
Nominal operating temperature: Up to +250°C
Temperature accuracy: +/- 2°C
Doors: 1 single leaf door
Base: The oven is provided with a structured insulated bottom with rails for loading the parts holder trolley
Finish: Oven interior made of AISI304 stainless steel with inner chamber welded completely, exterior made of carbon steel painted RAL 7035 with cycle for high temperatures
Control panel (Process + Logic): Built in control panel and wiring ducts. Heating process control in PID mode