More

Contact

  • ITALY Via Artigiani, 37
    23874 Montevecchia (LC)
  • CONTACT tel. +39 039 578 051
    mail@amarc.com

INDUSTRIAL OVEN FOR THE FIRING OF BIOMEDICAL COMPONENTS (3 INDEPENDENT ZONES)

Industrial Ovens and Dryers Firing

The oven was designed to perform with an extremely accurate cycle.

The requirement of the process involved work cycles at temperatures of +200°c, with accuracy +/-1°c with respect to the set point.

The accuracy of the distribution of the temperature was based on the need to avoid influencing the good quality of the product, criticality of extreme importance owing to the market sector in which the customer operates.

4H10A

Oven with forced ventilation, equipped with 3 independent zones for the firing of biomedical components.
Detail of oven front

5.i16b-new

Oven with forced ventilation, equipped with 3 independent zones for the firing of biomedical components.
Detail of oven ready for loading

5.I.16.C

Oven with forced ventilation, equipped with 3 independent zones for the firing of biomedical components.
Detail of door + oven interior, zone 2

5.I.16.D

Oven with forced ventilation, equipped with 3 independent zones for the firing of biomedical components.
Detail of oven interior, with probes for calibration operations

5.I.16.E

Oven with forced ventilation, equipped with 3 independent zones for the firing of biomedical components.
Detail of control panel

Technical data

Thermoregulation areas: 3
Working dimensions WxDxH in mm: 300x1000x1200 (each compartment)
Installation site : Indoor
Heating power supply: Electric
Nominal operating temperature: Ambient temperature +5°c to +200℃
Temperature accuracy: +/- 1°C
Doors: 2 front/rear single leaf doors for each zone, for FIFO loading mode
Base: The oven was constructed with insulated bottom with structure on feet
Finish: The entire oven is made of AISI304 stainless steel, exterior painted RAL 7035 with standard cycle.
Control panel (Process + Logic): Built in control panel and wiring ducts. Heating process control in PID mode
Optional: 3.5" touch screen programmer panel for control of the temperature cycles and data recording.
Interior of doors made of AISI304 stainless steel.
Double front/rear door with fifo loading mode.
Doors with inspection window and internal light.
Ceiling-mounted parts-holder rails to hold the workpieces.
Interlocked extraction cycle with heating cycle and performed by the customer's central system.